Attwood Flush Hatch Pull

HOW TO INSTALL ATTWOOD FLUSH HATCH PULL

Needed for Installation

• Center punch or awl
• 1-5/8” hole saw
• Small hand saw
• Drill and suitable drill bits
• Screwdriver
• (4) #6 or #8 bugle head screws

Installation

Mark Installation Hole

• Select a location that will not interfere with hatch frame.
• With handle facing edge of hatch, place template in desired location. Ensure that template is parallel with hatch, so that hatch pull will be straight when installed.
• Using punch or awl, mark hatch trough template at four attaching screw locations, then mark the two installation hole centerlines.

Note: The two installation holes must be marked on-line to ensure proper hatch pull alignment.

Drill Holes

• Drill two installation holes with the 1-5/8” hole saw. Use hand saw to remove material between installation holes.
• With handle opening facing edge of hatch, place bottom portion of hatch pull into installation hole and check for proper fit.
• Position top portion of hatch pull and ensure that screw holes are aligned with marks on hatch-if not, make a new mark through screw holes.
• Drill all four attaching screw holes.

Install Hatch Pull

• Install bottom portion of hatch pull first, then top portion. Ensure handle opening is facing edge of hatch.
• Install and tighten four attaching screws.

Information sourced from the Attwood Flush Hatch Pull Installation Instructions