Johnson - Evinrude 0767244 Loctite Gasket Maker 51817

Johnson - Evinrude 0767244 Loctite Gasket Maker 51817

Genuine OEM Johnson/Evinrude part. Designed for use as a gasket dressing on pre-cut gaskets for flexible joints or as a form-in-place chemical gasket for rigid assemblies. Allows for expensive gasket inventories to be reduced and outperforms conventional gaskets by offering a superior seal and eliminating fastener retorquing.

Special Order Item.

To Make a Gasket

1. Clean both flange surfaces. Remove paint, dirt, grease, or old gasket completely.
2. Spray Loctite Klean 'N Prime on one surface only. Allow to dry 1-2 minutes.
3. Apply a continuous bead of sealant to the unprimed surface.
4. Assemble mating surfaced with minimal lateral movement. Excess sealant can be wiped away with a cloth and shop solvent.

To Dress a Gasket

1. Clean both flange surfaces. Remove paint, dirt, grease, or old gasket completely.
2. Spray Loctite Klean N' Prime to both flange surfaces. Allow to dry 1-2 minutes.
3. Completely cover both sides of the pre-cut gasket with sealant.
4. Place coated gasket on flange and assemble mating surfaces with minimal lateral movement.

California Residents: WARNING Cancer and Reproductive Harm - P65Warnings.ca.gov